Crown, meet ceiling.
Compound cuts for corners, rakes & the transitions between.
Signed from level, following A → joint → B. Positive rises; negative falls. A peak uses A positive and B negative. Measure the molding run, not roof pitch.
Both start at 30°. Change either side independently. Enter positive angles above horizontal: A rises toward the ridge; B falls away from it. Measure along each crown run.
The ridge beam runs square out from this wall. Each crown end fits its own vertical side face. Beam width changes the cut positions, not these end angles; measure the finished lengths on site.
Mirror reverses travel: A/B exchange and inclinations change sign. Inside/outside remains the same.
Spring angle S
Angle from the wall to the straight crown back reference line, in a section square to the run. 52/38 crown normally uses 38° from wall. Use the actual installed spring; both pieces use the same spring. The level ceiling line here is a reference illustration; vaulted ceiling contact is a separate check.
Run inclination
Use a digital level along the run. A ceiling slope only equals this angle when the run follows that slope. All supported walls are vertical; twisted stock and differing profiles are outside this version.
Flat on the saw
Seat the back reference plane flat; decorative face up. Ceiling edge at the fence, wall edge toward you. Directions are viewed from the operator: miter describes the blade's front moving left/right; bevel describes its top tilting left/right. Use a dual-bevel saw for these placements.
Geometry, limits & reference checks
Identical profiles and sizes, equal installed spring, vertical walls and no roll about the run. A 3D frame models each piece. A reflection across the joint plane must align both profile axes before settings are shown. Horizontal formulas are not reused for rakes.
A corner angle is the smaller angle between wall traces in plan. For outside corners enter 90°, for example, rather than the reflex 270°. A slope change on one wall is defined by both run inclinations; the elevation included angle is 180° minus their difference.
The two-joint transition uses a level intermediate piece on B's wall. End cuts do not establish its length or verify contact with a sloping ceiling. Lay out the stock width, profile, shoulder clearance and transition size on site; back-edge relief or a different detail may be necessary. Arbitrary rolled crown, nonvertical walls and different springs require more measurements and are unsupported.
Reference: 38° spring / 90° horizontal corner → 31.62° miter, 33.86° bevel. Milwaukee saw manual · Gary Katz on cathedral transitions